To mark your cut for the bottom angle on the speaker stand legs, lay the board assembly on the plywood template again, and use the plywood edge to scribe the non-angled end of the board assembly. Be sure to consider which wood species (light or dark) you want on the inside and outside of your finished speaker stand legs, and keep that in mind when making your angle cuts.
I would definitely stick with the vapor barrier under the floor to avoid moisture from breaking up the OSB. try to build the base high enough to keep it dry and allow airflow to dry it out under there. FYI I recently repaired a neighbor's shed roof that must have been partially repaired before with plywood. The OSB was fine under the shingles, but the plywood was wrecked due to moisture. I would stick with OSB. Since you live here in NOVA, details will be a little more helpful to you. I really can't use the shed in the summer without the AC on. It gets direct sun and gets up to the 90's in there with out any air movement. I am planning on eventually lining the inside of the ceiling with that thin reflective insulation to bounce back some of the heat.

Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.
Just stumbled across your article and it’s right on time as I am about to launch a special events venue (ballrooms, meeting rooms, outside garden area, outsourced caterer, etc). Not sure what type of zoning this business falls under. I read that zones are usually for office, retail, industrial and leisure. Any idea what type of zone I should be looking for? Also first time trying to get a commercial space for this type of business, any specific suggestions?
Whether you plan to go it alone or hire a professional, there are many resources available to help you plan and execute your retail store layout. If you don’t feel comfortable tackling the project yourself, a professional retail store planner, interior designer, or display designer can turn your dreams into reality. Or if you want to handle it all yourself, store planning software and other online idea resources can make the job easier.
What about when you’re camping? Well, most campgrounds (including many free National Forest and BLM campgrounds) have some sort of bathroom situation. If there’s not an actual running water bathroom, you’ll typically find pit toilets (aka vault toilets), which are basically much nicer/cleaner permanent porta-potties. We also recommend picking up a good poop shovel for those times you’re camping in a wilderness area without bathrooms.
Note: This article will not include considerations for costs by independent developers or offshore firms. As I have written about cost differences in previous articles, those costs vary widely. Instead, this app cost resource focuses on what it would take to have a quality team of professionals build different kinds of apps. That could be done in-house, by building your own team, or by contracting a third party agency like Savvy Apps.
By completing a form on this website, you will be able to receive email correspondence from Canadian Woodworking.   These emails may include information on upcoming events or special offers for subscribers. If you do not wish to receive email correspondence please email orderdesk@canadianwoodworking.com  and ask to be removed from our email list. Every email that we send to you will include an "opt-out" from receiving future email correspondence. 
If you want to hit the road as soon as possible, then a Class B/C RV camper is a great option to consider. These vehicles are typically move-in ready, and barring any mechanical issues shouldn’t need much customizing before hitting the road. Class B campers (aka “campervans”) are built inside a van body, while Class C campers have a custom body built on a van cab/chassis.
One of the things that draws me to the online woodworking community is amount of passion people show are willing to share. Your shop build is a fine example of your willingness to let us in on your passion. You could have said “I’ll be back in a few months when its done” and most of us would have waited but instead you turned it in to a summer of updates and dream shop discussion. Thanks!
The time of the travel agent might be passing, but people are still looking for those with a knack for more nontraditional travel coordination. If you always plan the perfect vacations complete with beautiful hotels, the ideal location, and a bevy of delicious restaurants lined up for every evening, consider advertising your services as a more modern approach to travel planning.
If you have a small shop, you're probably not going to have the option of milling your own lumber to square. So the easiest way to go is to buy boards in the thickness and width you'll need. When buying sheet stock at a lumberyard or home center, the employees there can usually cut boards or sheets down to approximate sizes for you on a panel saw–sometimes for free, but typically for a fee.
A good starting point here is to write down two or three keywords that you think define your brand and then allow all your design choices to be guided by those words. For example, a local cheese shop could be organic, artisanal, and authentic; a wine bar could be sophisticated, 1920s, French; or a local specialty food store could be gourmet, helpful, natural.
You see, everyone can make money with his/her hobby, and I am going to reveal it to you in a minute… Ultimate Small Shop Ebook Download There are millions of people who have the same hobbies and interests just like you. Everyone is searching for more information about their hobbies and passions. Take a guess – what is the best place to find the information today? I think you will agree that the World Wide Web (the Internet) is one of the best places on the Earth to look for information related to your hobby. Millions of people use the Internet to find the answers to the questions they have, to solve the problems they encounter every day. So, how could you make money with your hobby? It’s simple – build your own web site (online business) about your hobby. Ken Evoy, internationally acclaimed Internet marketer, developed a system – SiteBuildIt! (SBI!) – that helps anyone to create professional websites about his/her hobbies, interests and passions. Hundreds (maybe even thousands) of SBI! users have already quit their jobs and now are making a living from the comfort of their own homes, doing what they love – creating web content about their hobbies. Each web site built by SBI! is search engine optimized. It means that when you build your own web site with the SBI! tools, the traffic to your web pages is guaranteed through search engines. And it doesn’t matter what your hobby is – Ken takes you by hand and explains how you can make money from the traffic received to your web site. What matters is – you create information-rich content pages about what you know and love – about your hobby! Ultimate Small Shop discount If you think that you cannot write web content – forget it, you can! – SBI! will guide you step-by-step from developing your web site’s concept to brainstorming hundreds of profitable related keywords; building a themed web site; generating motivated, targeted search engine traffic that wants to click on your recommendations, links to the related products sold by merchants that you will represent. Note that this is not a “get rich quick” scheme. It will require lots of your energy, work and time. The bottom line is that you will have a hobby that makes money for you!I’ve always liked to make gadgets and gizmos that have some function, either useful or not so useful. It started with the simple things that many kids make – slingshots, a simple bow, and arrow, a toy boat. Occasionally I made more involved items such as a canoe and a dune buggy. Then there was the grass hut – 12 feet across, octagonal in shape, and thatched top to bottom with a thick layer of grass. I built it in a remote location, near a strip mine filled with water. Hauled the cut grass in a 1972 Volkswagon convertible with the top down. Piled the grass high in the back seat. It must have taken a dozen trips back and forth from a nearby hay field. Simple things appeal to me more than costly homemade items. A small project lets me pursue an interest without interfering with other goals. Ultimate Small Shop Tips A project with a small amount of time invested seems more like entertainment.
For the large square windows near the tailgate I just used those big “magic auto shades” like these, which fit perfectly to cover up those side windows and the back window by the tailgate (I had four in the canopy) and another set up in the cab for my actual window. As for the longer side windows I just used a USPS box, haphazardly stuck up against the window. Nothing fancy.

Starting your own small business can be an incredibly rewarding experience both personally and financially. However, like anything worthwhile, it takes a great deal of time and effort to be successful at it. Your results will depend on how much you are willing to apply yourself. The lessons in How to Start a Small Business 101 are designed to give you a leg up on the competition so you can hit the ground running. Now all you’ve got to do is bookmark this page, free up some time, grab a cup of coffee, and start making your way through each section.

×